Lab X Creations
Lifeboat Urethane Pour Foam - 2lb Density - 2 Gallon Kit 2-Part Closed Cell Rigid Pour Foam - Fast-Acting Formula - Great for Boat Buoyancy, Flotation, Filling, Soundproofing, & Insulation
Lifeboat Urethane Pour Foam - 2lb Density - 2 Gallon Kit 2-Part Closed Cell Rigid Pour Foam - Fast-Acting Formula - Great for Boat Buoyancy, Flotation, Filling, Soundproofing, & Insulation
Couldn't load pickup availability
- ✅ KIT SIZES AND CONTENTS - Review product photos for a detailed view of what is included with each kit type
- ✅ LIQUID EXPANDING FOAM to RIGID INSULATION - The ideal foam for marine flotation foam applications, our liquid urethane foam is also great for soundproofing and insulating. Use it to fill dock floats, gaps and cavities in boats and a multitude of other applications.
- ✅ IMPRESSIVE STRENGTH - Urethane is both lightweight and extremely reliable. After fully curing to its rigid form, our insulating foam boasts a 95 to 98% closed cell structure with a 2lb density. See images for expansion chart.
- ✅ EASY TO USE - Great for all boaters, novice to expert boat owners! This pourable liquid urethane foam is very easy to work with and expands rapidly. Mix Parts A & B at a 1:1 ratio for best results.
- ✅ QUICK SETTING - Our expanding foam has a short curing time and minimal shrinkage, leaving your boat ready for use just hours after application. The foam hardens in place within 10 minutes
- ✅ LONG LASTING RESULTS - Once cured, urethane is unaffected by gasoline, oil, fresh or saltwater, or solvents, making it one of the most dependable and enduring materials for boating needs
I purchased this for a project at our cabin but that didn't work out, so it was just sitting in our garage. I installed a new yard light and needed to secure the pole in the hole. I had heard about using foam so I thought I'd give it a try. My hole was 18" deep and about 7" wide. I mixed up about 2 cups of this and poured it in. Wow! It filled the hole and bulged out of the ground. This stuff is tough, and also difficult to remove from anything that it cures on. As a result, the post is secure and I am delighted with the result.
Works perfectly
Exactly what I thought it would be. Worked great
Bottles were sealed perfectly when I received them. They mixed great and expanded as good or better than a more expensive foam I bought elsewhere.
Used this Floatation Foam to restore a 1986 Sea Nymph Striper CC 17. Needed to replace the two rear foam pockets between the splashguard and transom. Cleaned out the space and sealed all corners using duck tape (ceiling/void expansion will work as well). Just make sure every pocket is covered as this will seep into the smallest spaces. Mixed half of the 2 gallon (1 gallon from each bottle) into the bucket, used a long metal mixer with my drill and mixed it for up to a minute as the contents will start to do a chemical reaction start pouring into the desire space as soon as possible and dont be afraid to add a little extra vs using less as you may have to add more on top of the previous pour and it will not look good in unison. Its that easy. Look at a few youtube videos on 2 part polyurethane pours or floatation foam. You will understand why prepping is very important and you will get it right the first time. Not intimidating at allP.S it is a chemically reactive so wear gloves or your skin may burn
Share
